cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
389
Views
0
Helpful
1
Replies

ACS/ LEAP and 7921G

johnsonk1024
Level 1
Level 1

Hello,

I am having issues with our 7921G's authenticating through our ACS. I am using WCS to control two WiSM controllers. Currently, the SSID is set up to use WPA+WPA2 (AES and CCKM). The AAA settings point to our ACS server and I have LEAP authentication enabled and pointing to a profile. I have the phones configured with the same profile information but in ACS I get and error saying " EAP type not configured". I have gone through the phone and reset all passwords and verified the SSID. Can anyone advise on what to (re)check or where to look?

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

When you get that error on the ACS, it usually means that you didn't configure that EAP type the phones are using on the ACS itself. Try to get a laptop associated and authenticated first, before you try it on the phones.

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: