Batch WLC CLI commands

Unanswered Question
Aug 13th, 2008

I'm building scripts to help automate large deployments. Is there a way to execute a CLI command on all registered APs, like with a wildcard?

for example, to set a custom power level on multiple APs, it's necessary to do this:

config 802.11b disable AP01

config 802.11b txpower ap AP01 3

config 802.11b enable AP01

config 802.11b disable AP02

config 802.11b txpower ap AP02 3

config 802.11b enable AP02

config 802.11b disable AP03

config 802.11b txpower ap AP03 3

config 802.11b enable AP03

Is it possible to do something like this?

some command to disable all b/g radios

config 802.11b txpower ap [wildcard] 3

some command to enable all b/g radios

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
beabrams Thu, 08/14/2008 - 03:53

config 802.11b disable network (for all of them)

(Cisco Controller) >config 802.11b txPower global ?

auto Enables auto-RF.

once Enables one-time auto-RF.

Enter transmit power level

this was on a WLC running 5.0.148.2, but I think the commands are in lower versions.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode