08-14-2008 02:22 AM - edited 03-14-2019 02:42 AM
Hi!
When performing first node setup procedure, after filling in the Unified Configuration Page, the Systems Parameters Configuration page does not open (it appears done at the bottom but it's all white).
What could be the problem?
Best Regards,
Ana
08-15-2008 06:27 AM
Not sure - browser type ?
08-18-2008 03:19 AM
Hi!
The browser is Internet Explorer 6.0.3790.1830
10-01-2008 02:32 AM
Hi,
I have the same problem, using CRS 5.0(2) fresh out of the box, installed the system by the book.
Did you get a solution for this problem?
I urgently would like to know what the problem was?
Thanks in advance,
Chris
10-02-2008 06:05 AM
Hi!
Check licenses and make sure the AXL service password is the same used in the CM.
Best Regards,
Ana
10-02-2008 06:09 AM
Thanks for the reply.
I managed to use another customer's lcense just to prove this, based on another thread I saw. This was indeed the case. I had to go to TAC for a license in the end as the one I had was not working.
They came good and everything sprang into life.
Thanks,
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide