cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
534
Views
0
Helpful
5
Replies

CCX5.0(2) - Initial Setup of CRS

abartolomeu
Level 1
Level 1

Hi!

When performing first node setup procedure, after filling in the Unified Configuration Page, the Systems Parameters Configuration page does not open (it appears done at the bottom but it's all white).

What could be the problem?

Best Regards,

Ana

5 Replies 5

pbaustin
Level 1
Level 1

Not sure - browser type ?

Hi!

The browser is Internet Explorer 6.0.3790.1830

Hi,

I have the same problem, using CRS 5.0(2) fresh out of the box, installed the system by the book.

Did you get a solution for this problem?

I urgently would like to know what the problem was?

Thanks in advance,

Chris

Hi!

Check licenses and make sure the AXL service password is the same used in the CM.

Best Regards,

Ana

Thanks for the reply.

I managed to use another customer's lcense just to prove this, based on another thread I saw. This was indeed the case. I had to go to TAC for a license in the end as the one I had was not working.

They came good and everything sprang into life.

Thanks,

Chris

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: