Not able to setup pri-group in controller T1 0/0/0

Unanswered Question
Aug 14th, 2008
User Badges:

I have a remote site with a VWIC2-2MFT-T1/E1 Module in a Cisco 2811 router. They are trying to configure a PRI group underneath the controller interface. However the command is not being accepted. Customer has added the ISDN switch type statement (isdn switch-type primary-5ess)in the global area. The following error is generated when configuring "pri-group timeslots 1-24".


pri-Group statement is not available underneath the controller interface


Serial interfaces are not available either. The IOS is 12.4(9)T6. I found a bug similar to this issue but was in 12.2 code.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Richard Burts Thu, 08/14/2008 - 09:40
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Richard


What if they try configuring channel-group instead of pri-group


HTH


Rick

khaile Thu, 08/14/2008 - 13:36
User Badges:

controller T1 1/0

framing esf

linecode b8zs

cablelength long 0db

pri-group timeslots 1-24


do you want to try this on global config?

rlortiz Thu, 08/14/2008 - 14:19
User Badges:

Hey Guys,


I just got more information that changes the whole thing. I found out they are seeing the following error:


% Not enough DSP resources available to configure pri-group on controller T1 0/0/0


There are no PVDMs because they just want to do ISDN. I had them use an IOS with only the IP BASE feature to take away the voice support. This fixed the issue.


Sorry, I was not aware at the time that it was bogus information.


Thanks for the help, anyway.

Actions

This Discussion