dial-peer cor-list problem

Unanswered Question
Aug 14th, 2008

Hi,

I want to set up a dial-peer cor list to prevent my directly attached FXS ports from dialling internationally, and to stop my SRST devices calling internationally. I have set up some cor lists etc, but find that during normal running, calls from my IP Tel phones are coming in on dial peer 0.

According to my thinking, they should be coming in on dial-peer 200, based on the destination pattern:

dial-peer voice 200 voip

corlist incoming UNRESTRICTED

corlist outgoing CCM-AND-SRST-ONLY

description 1ST PREFERENCE OUTBOUND PEER TO CCM SERVER (1ST SUBSCRIBER)

destination-pattern 2...

progress_ind setup enable 3

modem passthrough nse codec g711alaw

voice-class codec 1

voice-class h323 1

session target ipv4:172.19.70.11

dtmf-relay h245-signal h245-alphanumeric

no vad

any ideas?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Thu, 08/14/2008 - 18:53

lets say u have the folowing example

dial-peer cor custom

name int

name local

dial-peer cor list int

member int

dial-peer cor list local

member local

dial-peer cor list LocalCalls

member local

dial-peer cor list International

member int

now this is for internation calls

dial-peer voice 9011 pots

corlist outgoing int

destination-pattern 9011T

port 1/0:23

prefix 011

and this for local calls

dial-peer voice 7 pots

corlist outgoing local

destination-pattern 9[2-9]......

port 1/0:23

forward-digits 7

just goo to the fxs port then apply

cor incoming LocalCalls

this case he has only access to the local calls dia-peer based on the above example

just follow the idea and if u want any more details juist post it here

good luck

please if helpful rate

Actions

This Discussion