Hi,
I want to set up a dial-peer cor list to prevent my directly attached FXS ports from dialling internationally, and to stop my SRST devices calling internationally. I have set up some cor lists etc, but find that during normal running, calls from my IP Tel phones are coming in on dial peer 0.
According to my thinking, they should be coming in on dial-peer 200, based on the destination pattern:
dial-peer voice 200 voip
corlist incoming UNRESTRICTED
corlist outgoing CCM-AND-SRST-ONLY
description 1ST PREFERENCE OUTBOUND PEER TO CCM SERVER (1ST SUBSCRIBER)
destination-pattern 2...
progress_ind setup enable 3
modem passthrough nse codec g711alaw
voice-class codec 1
voice-class h323 1
session target ipv4:172.19.70.11
dtmf-relay h245-signal h245-alphanumeric
no vad
any ideas?