cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
339
Views
0
Helpful
2
Replies

gk/ipipgw to gk/ipipgw

tonny.ausema
Level 1
Level 1

In the following setup:

vct - gk/ipipgw - fw - internet - fw - gk/ipipgw - vct

2 vct's are registered on a gatekeeper with integrated ipipgw (cube) on 2 different locations. When setting up a session from vct1 to vct2 the call is terminated on the incoming call leg with a normal call clear.

attached the config on the receiving gk/ipipgw and the outcome of: sh gatek call.

The config of GK1 is similar.

Any ideas why the call isn't passed on two the outgoing call-leg?

2 Replies 2

Marwan ALshawi
VIP Alumni
VIP Alumni

as i can see there is firewall in the path

have enabled the h323 signaling thorugh these firewalls and have enabled h323,h225 inspection ??

Thanks for your suggestion. There is a h323 enabled firewall between the 2 BE's passing h323, h225. And I can actually see the call comming in on the 1st call leg of the 2nd BE but it terminates there.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: