Translation Patterns- timers

Unanswered Question
Aug 15th, 2008
User Badges:
  • Silver, 250 points or more

I`m using TP`s to configure the cluster- all my internal calls go to the TP against a Specific Pattern and get routed correctly however there is a delay going through the TP`s - is there a setting which decreases it - by default the Urget is ticked and it is not the 302 timer- thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jaime Valencia Fri, 08/15/2008 - 06:48
User Badges:
  • Cisco Employee,
  • Hall of Fame,


TP do not have IDT, there must be something else that causes the IDT on your system as after the called party is translated it's subject to DA again.

look at the route plan report for overlapping

thousands of possible options can cause some delay



if this helps, please rate

iptuser55 Fri, 08/15/2008 - 07:20
User Badges:
  • Silver, 250 points or more

There are other matches based upon the resultant number however only around 7 of the possible 16 are matched due to their Partitions only being the CSS of the TP . I know that TP`s have the potential to loop around 15 x. Is this delay normal in that it is quite noticeable

Marwan ALshawi Fri, 08/15/2008 - 07:25
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

try to decrease the inter digit time out


This Discussion