08-15-2008 06:31 PM
I set up my company's VPN network on a PIX506E firewall. but when i tried to connect to the vpn from my ipod touch, it failed. it uses IPSec over UDP. does ipod touch/ipohone only work with IPSec over TCP? If so, what differently i need to do to setup my pix506E to use IPSec over TCP instead?
Thanks,
Tharaka
08-18-2008 09:18 AM
Hello Tharaka,
The Apple iPhone/iTouch only works with IPSec over NAT-T if it is connecting through a NAT device or just IPSec. Its the client side limitation.
So, you might want to enable IPSec over NAT-T on your PIX 506E to support iPhone/iTouch IPSec connections.
Command Usage:
isakmp nat-traversal [natkeepalive]
You can enter a keepalive value of 20. (Its in seconds.
http://www.cisco.com/en/US/docs/security/pix/pix63/command/reference/gl.html#wp1027312
Please rate this post if it helps.
Thanks
Gilbert
08-22-2008 09:06 AM
Hi Gilbert,
Just checked the settings and it's always been enabled. any other thoughts?
thanks,
tharaka
08-22-2008 09:29 AM
Hi Gilbert,
Just checked the settings and it's always been enabled. any other thoughts?
thanks,
tharaka
08-22-2008 10:03 AM
Hi Gilbert,
Just checked the settings and it's always been enabled. any other thoughts?
thanks,
tharaka
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: