3560 Baud rate

Unanswered Question
Aug 17th, 2008
User Badges:

Hi all,


I changed the baud rate for the console to 115200bps to speed up an IOS transfer through xmodem but cannot reset it back to the default 9600.Tried "set BAUD 9600" & "unset BAUD" seperately under switch: prompt but with no luck.Any help is much appreciated.

Thanks,


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (1 ratings)
Loading.
Giuseppe Larosa Mon, 08/18/2008 - 02:17
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello,

try to reload it and to access it via telnet then modify the confreg in order to have again 9600 bps


or try to use confreg at rommon prompt.

It will make some questions and one of them is about console speed


see :

http://www.cisco.com/en/US/products/hw/switches/ps663/products_password_recovery09186a00800945f7.shtml




Hope to help

Giuseppe

janesh_abey Mon, 08/18/2008 - 14:22
User Badges:

Hi Qiusar,


Many thanks fore the feedback but confreg is not supported on 3560.Found the cause.basically the console baud was change to 115200 which was not changed back to defualts.unset BAUD at switch: defaulted the baud to 9600 but as there was a different setting on the startup, output was not readable.

cheers

Actions

This Discussion