1242AG Fault Light

iain.mccutcheon · ‎08-18-2008

I have a number of 1242AG's installed in a factory, and one of which will not operate properly, as it is on a girder about 20m high, I cannot see which LED, but either the ethernet or radio LED is red, and the status LED is green. This occurs about halfway through the boot process.

Cisco network assistant can see the device, but it cannot be pinged and cannot be telnet-ed to!

HELP!

Thanks.

Scott Fella · ‎08-18-2008

Take a look at this link... hope it helps:

http://www.cisco.com/en/US/docs/wireless/access_point/12.3_7_JA/configuration/guide/s37trb.html#wp1065824

Is this an autonomous AP of LAP?

-Scott
*** Please rate helpful posts ***

iain.mccutcheon · ‎08-20-2008

Autonomous AP.

Thanks for the link, I think I will be able to manage now. I could not find that page no matter how much I searched!

Thanks.

Scott Fella · ‎08-21-2008

The matrix was on the link I sent you. You just need to figure out which light is what.

http://www.cisco.com/en/US/docs/wireless/access_point/12.3_7_JA/configuration/guide/s37trb.html#wp1065983

http://cisco.com/en/US/partner/docs/wireless/access_point/1240/quick/guide/ap1240qs.html#wp41161

-Scott
*** Please rate helpful posts ***

iain.mccutcheon · ‎08-21-2008

Yeah I got it, just meant the link you sent me was the one i needed but could not find myself!

Thanks again.

Scott Fella · ‎08-22-2008

Ah. Well hopefully you get it working.

-Scott
*** Please rate helpful posts ***

iain.mccutcheon · ‎08-22-2008

Should do! Thanks again.