Identifying inbound vs. outbound

Unanswered Question
Aug 18th, 2008

Is there a way to tell if calls on my MGCP gateway are inbound or outbound on my T1 PRI ?

I was running the following commands, and none gave me an indication. I am sure there is a command for this...

sh voice call sum

sh voice call stat

sh call active voice brie

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3.5 (3 ratings)
mattcalderon Mon, 08/18/2008 - 09:07

I normally just do a quick look at what channels are in use and then verify if telco is sending in top down and we are sending out bottom up.


jbarcena Mon, 08/18/2008 - 09:34

you can also use CCM detailed traces. debugs voice ccapi inout and debug isdn q931

cplatt01 Mon, 08/18/2008 - 10:36

I was hoping to avoid debugs...but you are correct.



This Discussion