Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
311
Views
11
Helpful
4
Replies

Identifying inbound vs. outbound

cplatt01
Level 1
Level 1

‎08-18-2008 08:55 AM - edited ‎03-15-2019 12:41 PM

Is there a way to tell if calls on my MGCP gateway are inbound or outbound on my T1 PRI ?

I was running the following commands, and none gave me an indication. I am sure there is a command for this...

sh voice call sum

sh voice call stat

sh call active voice brie

Labels:
0 Helpful
4 Replies 4

mattcalderon
Level 4
Level 4

‎08-18-2008 09:07 AM

I normally just do a quick look at what channels are in use and then verify if telco is sending in top down and we are sending out bottom up.

Matt

cplatt01
Level 1
Level 1
In response to mattcalderon

‎08-18-2008 09:10 AM

Never thought about it that way....good idea.

0 Helpful

jbarcena
Level 9
Level 9

‎08-18-2008 09:34 AM

you can also use CCM detailed traces. debugs voice ccapi inout and debug isdn q931

cplatt01
Level 1
Level 1
In response to jbarcena

‎08-18-2008 10:36 AM

I was hoping to avoid debugs...but you are correct.

Thanks!

0 Helpful
Customers Also Viewed These Support Documents