ISDN channel not available

Unanswered Question
Aug 19th, 2008
User Badges:

Hi Guys,

I am trying to get incoming calls to work.I`m using h323 and only 18 channels.I am getting channel not available tho voice port summary shows my channels are up :


Aug 19 07:57:36: ISDN Se0/1/0:15 Q931: RX <- SETUP pd = 8 callref = 0x0001

Sending Complete

Bearer Capability i = 0x9090A3

Standard = CCITT

Transfer Capability = 3.1kHz Audio

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98381

Exclusive, Channel 1

Calling Party Number i = 0x2183, '7795806070'

Plan:ISDN, Type:National

Called Party Number i = 0x81, '579260'

Plan:ISDN, Type:Unknown

Aug 19 07:57:36: ISDN Se0/1/0:15 Q931: TX -> CALL_PROC pd = 8 callref = 0x8001

Channel ID i = 0xA98381

Exclusive, Channel 1

Aug 19 07:57:38: ISDN Se0/1/0:15 Q931: Applying typeplan for sw-type 0x12 is 0x2

0x1, Calling num 7795806070

Aug 19 07:57:38: ISDN Se0/1/0:15 Q931: Applying typeplan for sw-type 0x12 is 0x0

0x1, Called num 579260

Aug 19 07:57:38: ISDN Se0/1/0:15 Q931: TX -> SETUP pd = 8 callref = 0x00FB

Sending Complete

Bearer Capability i = 0x9090A3

Standard = CCITT

Transfer Capability = 3.1kHz Audio

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA9839F

Exclusive, Channel 31

Calling Party Number i = 0x2183, '7795806070'

Plan:ISDN, Type:National

Called Party Number i = 0x81, '579260'

Plan:ISDN, Type:Unknown

Aug 19 07:57:38: ISDN Se0/1/0:15 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x80

FB

Cause i = 0x82AC - Requested circuit/channel not available

Aug 19 07:57:38: ISDN Se0/1/0:15 Q931: TX -> DISCONNECT pd = 8 callref = 0x8001


Cause i = 0x82AC - Requested circuit/channel not available

Aug 19 07:57:39: ISDN Se0/1/0:15 Q931: RX <- RELEASE pd = 8 callref = 0x0001

Aug 19 07:57:39: ISDN Se0/1/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x80


Any thoughts ??

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Tim Smith Tue, 08/19/2008 - 04:13
User Badges:
  • Silver, 250 points or more

Hi,


From your debug, your requesting channel 31..


How is your E1 controller configured? Is it configured with timeslots 1 - 31 or 1 - 18?


You can change the order it selects the channels, but that wouldnt be the proper fix.

You want to stop your router selecting channels that arent available :)



Cheers,


Tim

Actions

This Discussion