PBR on Cat 4500 with Supervisor 6E

paulomv · ‎08-19-2008

Hi all,

I'm trying to configure PBR on a Catalyst 4500 with Supervisor 6E running version 12.2(46)SG Enterprise Services.

I'm not able to configure PBR on the interfaces using the command ip policy-map.

Did this feature disappear on this Supervisor???

I've already searched on the Feature Navigator and PBR is not on the list for either license types!

I'm replacing a Sup3 that has that feature configured.

Any help?

Thanks,

Paulo

I

paulomv · ‎08-19-2008

OK, just checked that PBR is not supported on Supervisor 6-E.

Is there any reason for this? Will it be supported in the future?

middleeast · ‎08-19-2008

did you use same IOS 12.2.46.SG on SUP3 or not?

paulomv · ‎08-19-2008

The Supervisor 3 is running 12.2(25)EWA8.

I believe that PBR would be working on Sup3 on version 12.2(46)SG. The limitation is really on Supervisor 6-E which does not support PBR.

middleeast · ‎08-20-2008

may you pls try for me that whether PBR is working on SUP3 with 12.2(46)SG, because the feature navigator indicate that PBR is not supported for this IOS..thanks..

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

paulomv · ‎08-21-2008

Hi,

Don't worry about that version for Supervior 3 because version 12.2(46)SG is for Sup6-E only.

The latest version for Sup3 is 12.2.25-EWA14 which certainly supports PBR (Must be Enhanced L3 license) because Sup3 supports that feature.

The limitation I've found is in the Hardware not in the Software.