ACS shell command to restrict access

Unanswered Question
Aug 19th, 2008
User Badges:

I am trying to set up groups within ACS to have "show" privilege only, per the below link.


I have ACS set up and working for the network from the admin group allowing all access and it is working fine.


When I follow the instructions to allow only "ReadOnlyAccess", I can log into the devices, but do not have "enable" access.


I get an authenitcation error:


"T+ enable privilege too low"


Do I need to allow "enable" as well in the shell command?


http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00808d9138.shtml')

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dhananjoy chowdhury Wed, 08/20/2008 - 01:58
User Badges:
  • Silver, 250 points or more

Under the Advanced TACACS options, set the Max privilege of level 1 or higher..

Actions

This Discussion