Marwan ALshawi Tue, 08/19/2008 - 07:36
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

if u mean u want to send a call to an fxs from plar u need a pots dial peer


lets say u have fxs port 0/0/1 with number 222


diap-peer voice pots

destination-patren 222

port 0/0/1



and lets say ur fxo port is 0/1/0


do

voice-port 0/1/0

connection plar-opx 222


this way the call coming into the fxo will go directly to the fxs


IF u want the FXS to make a dirct dial when u just pick up the phone do the following on the FXS


voice-port 0/0/1

connection plar 333


call will go to number 333 but it need a

voip dial-peer to ur call manager


forexample


dial-peer voice 9 voip

destniation-patren 33.

session target ipv4:[ur CCM IP]


i am asuming u r usin H323 gateway



good luck


please, if helpful Rate

Rafael Jimenez Tue, 08/19/2008 - 08:18
User Badges:

one more question, if i have configured SCCP gateway for all my 6 fxs ports in the EVM module .

Must I unconfigure the port that i need for connection plar ?.

Can I leave the fxs port controlled by the call manager via sccp and add the plar command en the voice port?.

Thanks.

Marwan ALshawi Tue, 08/19/2008 - 16:12
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

i havnt worked with gateway

but as long as it is controled by the CCM try to find an optionin the port setting


or u can make the same idea as the document u have


good luck

Marwan ALshawi Tue, 08/19/2008 - 21:56
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

sory i didnt mean with a gateway i meant with that gateway type u use :))

Actions

This Discussion