cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2047
Views
5
Helpful
3
Replies

Bearer capability not implemented

bcarnot
Level 1
Level 1

AS5350XM - ISDN trunk connected to device, no PBX involved.

boot system flash c5350-jk9s-mz.124-19b.bin

****Debug log***

Aug 19 18:14:18.949: ISDN Se2/0:23 Q931: RX <- SETUP pd = 8 callref = 0x1C40

Bearer Capability i = 0x8090A2

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98381

Exclusive, Channel 1

Progress Ind i = 0x8283 - Origination address is non-ISDN

Calling Party Number i = 0x2183, '6199774592'

Plan:ISDN, Type:National

Called Party Number i = 0xC1, '5213100'

Plan:ISDN, Type:Subscriber(local)

Aug 19 18:14:18.953: ISDN Se2/0:23 **ERROR**: call_incoming: Received a call id 0x9F with a bad bearercap from 6199774592 on b channel 1

Aug 19 18:14:18.953: ISDN Se2/0:23 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x9C40

Cause i = 0x80C1 - Bearer capability not implemented

3 Replies 3

bfarouk
Level 1
Level 1

Included the following line.

voice-port 2/0:D

bearer-cap Speech

The bearer-cap command will have affect outgoing calls from the router towards the ISDN.

For inwards calls from the ISDN towards the router, you need to add the D channel command 'isdn incoming-voice modem' to allow the router to recognise the inwards speech bearer capability.

interface serial 2/0:15

isdn incoming-voice modem

This did the trick:

interface Serial2/1:23

no ip address

encapsulation hdlc

isdn switch-type primary-ni

isdn incoming-voice modem

no fair-queue

no cdp enable

Thank you very much for the reply.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: