license problem after restore full backup

Answered Question
Aug 19th, 2008
User Badges:

(This software installation requires reusing a license provided in a previous version. If a previous license is not available or proof of purchase validation was not performed, you may continue to install in NAG mode, while arranging with your Cisco representative to return this product and purchase a full licensed version.)


the above message is appeared after restore full backup of LMS2.6 with CS 3.0.6 and RME 4.0.5 and when I open any page IN GUI to run the validateupgrade command, after run this command, it gave me:

((

[email protected] # pwd

/opt/CSCOpx/bin

[email protected] # ./validateupgrade ld.so.1: validateupgrade: fatal: libstdc++.so.3: open failed: No such file or directory Killed

))

Correct Answer by Joe Clarke about 8 years 9 months ago

You need to setup LD_LIBRARY_PATH before running validateupgrade:


env LD_LIBRARY_PATH=/opt/CSCOpx/MDC/lib:/opt/CSCOpx/lib /opt/CSCOpx/bin/validateupgrade

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Tue, 08/19/2008 - 21:45
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

You need to setup LD_LIBRARY_PATH before running validateupgrade:


env LD_LIBRARY_PATH=/opt/CSCOpx/MDC/lib:/opt/CSCOpx/lib /opt/CSCOpx/bin/validateupgrade

Actions

This Discussion