Dynamic routing on FXO

Unanswered Question
Aug 19th, 2008

Hi there,

we have 8 FXO analog circuits(1+7 hunted) with one pilot number and 7 different numbers. Now lets say my pilot number is 7000 and other numbes are 7001 to 7007. I want all the calls coming on the number 7000 to be routed to the operator and calls on 7001 to be routed to specific DN.

how can this be done??

The gateway is registered with Call Manager over H.323.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Wed, 08/20/2008 - 00:45

let say ur first FXO port is 1/0/0 this go to number 7000

do the following

voice-port 1/0/0

connection plar-opx 7000

and do the same for each port puting the number u want like:

voice-port 1/0/1

connection plar-opx 7001

now u have to make voip dial peer to send these numbers to the call manager do the following

dial-peer voice 9 voip

destination-pattren 7...

session target ipv4:[ur callmanager IP]

this will work

u need to make sure in the callmanager that the significant digites on the gateway setting page seted to 4 or all to let the callmanager take the right number like 7000 or 7001

good luck

please if helful Rate

Actions

This Discussion