08-20-2008 12:59 AM - edited 03-15-2019 12:44 PM
Hi all,
I have a 2851-ccme router with a Vic2-2FXO and a EVM-HD-8FXS/DID with 2-6FXO cards.
IOS is c2800nm-advipservicesk9-mz.124-11.XW9.bin and the voice port configuration is:
voice-port 0/0/0
connection plar opx 843
caller-id enable
!
voice-port 0/0/1
connection plar opx 843
caller-id enable
!
voice-port 2/0/0
!
voice-port 2/0/1
!
voice-port 2/0/2
!
voice-port 2/0/3
!
voice-port 2/0/4
!
voice-port 2/0/5
!
voice-port 2/0/6
!
voice-port 2/0/7
!
voice-port 2/0/8
connection plar 843
caller-id enable
!
voice-port 2/0/9
connection plar 843
caller-id enable
!
voice-port 2/0/10
connection plar 843
caller-id enable
!
voice-port 2/0/11
connection plar 843
caller-id enable
!
voice-port 2/0/12
connection plar 843
caller-id enable
!
voice-port 2/0/13
connection plar opx 843
caller-id enable
!
voice-port 2/0/16
connection plar opx 843
caller-id enable
!
voice-port 2/0/17
connection plar 843
caller-id enable
!
voice-port 2/0/18
connection plar 843
caller-id enable
!
voice-port 2/0/19
connection plar 843
caller-id enable
!
voice-port 2/0/20
connection plar 843
caller-id enable
!
voice-port 2/0/21
connection plar 843
caller-id enable
I have 2 Premicells conected on port 2/0/13 and 2/0/16.
When I call the premicell number, on the screen of IP Phone show Unknown Number.
I have typed the debug vpm signal and the output is attached above.
And another problem that I have is the Voice port 2/0/14 and 15 they do not initialze on router startup. Why?
What can I do to repair the mistakes?
Thanks in advance,
08-20-2008 10:00 PM
Aug 20 11:48:13.142: [2/0/13] htsp_stop_caller_id_rx. message length 0htsp_setup_ind
Aug 20 11:48:13.142: [2/0/13] get_fxo_caller_id:Caller ID receive failed. parseCallerIDString:no data.
Could you please describe the current setup?
If you connect an analog phone directly u get caller ID?
08-20-2008 10:12 PM
Thanks for the reply,
I will try with an analog phone today and I will post the result!
08-28-2008 04:10 AM
Hi all,
I have tested today with an analog phone and the results are:
-- with one premicell I receive the caller ID and
--with the other one don't, so I will leave him out of the story.
What information should I provide more?
09-15-2008 01:46 AM
Could anyone tell me where is the problem???
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: