5510 active-standby failover

Unanswered Question
Aug 20th, 2008
User Badges:

I have two new ASA 5510s, with 7.2(2)10 configured for active/standby failover.

due to ASA interface limitation/availability, I am using only one interface for both LAN-base and stateful failover:


interface Ethernet0/3

speed 100

duplex full

!

interface Ethernet0/3.2

description LAN Failover Interface

vlan 20

!

interface Ethernet0/3.3

description STATE Failover Interface

vlan 30

failover is working, but I'm concern that when I enter “show failover” the firewalls don't see each other

any help?


thanks, kevin


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Farrukh Haroon Wed, 08/20/2008 - 19:04
User Badges:
  • Red, 2250 points or more

First of all you don't need sub-interfaces if you share the Failover/Stateful interface(s). Just use Eth0/0.


Secondly is it possible to post the output of 'show failover? and if possible show run failover.


Regards


Farrukh

ksvy_ksvy Thu, 08/21/2008 - 06:11
User Badges:

Farrukh, I messed and didn't use:

failover key xxxxx


once I entered the key, on both, sync' come right up and all works now


thanks, for responding


kevin

Farrukh Haroon Thu, 08/21/2008 - 06:32
User Badges:
  • Red, 2250 points or more

No problem, glad you have it working now.


Regards


Farrukh

Actions

This Discussion