Configuring WCCP

Unanswered Question
Aug 21st, 2008
User Badges:

I am trying to configure WCCP on my 6513 switch and use my management VLAN as the interface with that particular IP address as the WCCP router IP address(i.e IP Unnumbered) however I am getting his error:

DP6513(config)#int lo255

DP6513(config-if)#ip unnu

DP6513(config-if)#ip unnumbered vlan 1

Point-to-point (non-multi-access) interfaces only


I am running 12.2(18)SXF3


Please Help!!!!!



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
massimiliano.se... Thu, 08/21/2008 - 05:40
User Badges:
  • Silver, 250 points or more

Hi

" remember that the ip unnumbered command works on point-to-point interfaces only. When you configure the command on the Multiaccess interface (that is, Ethernet) or the loopback interface, the following messages are displayed:


RouterA(config)# int e0

RouterA(config-if)# ip unnumbered serial 0

Point-to-point (non-multi-access) interfaces only

RouterA(config-if)# ip unnumbered loopback 0

Point-to-point (non-multi-access) interfaces only "



Reference http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094e8d.shtml


I hope this helps.

Best regards.

Massimiliano.

Jon Marshall Thu, 08/21/2008 - 05:46
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

The error message says it all really. You can only use "ip unnumbered" on a point-to-point interface and both ethernet and the loopback are counted as multi-access. See attached link for more details


http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094e8d.shtml


Jon

Actions

This Discussion