Configuring WCCP

damrut5763 · ‎08-21-2008

I am trying to configure WCCP on my 6513 switch and use my management VLAN as the interface with that particular IP address as the WCCP router IP address(i.e IP Unnumbered) however I am getting his error:

DP6513(config)#int lo255

DP6513(config-if)#ip unnu

DP6513(config-if)#ip unnumbered vlan 1

Point-to-point (non-multi-access) interfaces only

I am running 12.2(18)SXF3

Please Help!!!!!

massimiliano.serafino · ‎08-21-2008

Hi

" remember that the ip unnumbered command works on point-to-point interfaces only. When you configure the command on the Multiaccess interface (that is, Ethernet) or the loopback interface, the following messages are displayed:

RouterA(config)# int e0

RouterA(config-if)# ip unnumbered serial 0

Point-to-point (non-multi-access) interfaces only

RouterA(config-if)# ip unnumbered loopback 0

Point-to-point (non-multi-access) interfaces only "

Reference http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094e8d.shtml

I hope this helps.

Best regards.

Massimiliano.

damrut5763 · ‎08-21-2008

Thanks!!!!!

Jon Marshall · ‎08-21-2008

The error message says it all really. You can only use "ip unnumbered" on a point-to-point interface and both ethernet and the loopback are counted as multi-access. See attached link for more details

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094e8d.shtml

Jon