cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1370
Views
5
Helpful
9
Replies

No Conference Bridge Error - CME 4.1

johnnywan
Level 1
Level 1

Trying to configure meet me conferencing on CME 4.1 2811 box. I have the dsp(s) and have the conference hardware command under telephony service. I also have the e-phone dn setup for my meet me number. When I go off-hook and hit meet me softkey I get dialtone, when I enter the meet me dn I get the error No Conference Bridge. I have been through the admin guide 10 times. Any suggestions from anyone would be appreciated.

9 Replies 9

bc
Level 1
Level 1

Your DSP-Farm is configured and registered?

Maybe try another IOS Version. I had a similar issue with cme and one of the 4.x Versions.

Yes it is. I will look into another IOS ver.

Thank you.

jbarcena
Level 9
Level 9

If you make a 'show dspfarm all' is your CB showing as registered?

Try a no sccp / sccp and check again

Good call - but that did not work.

Well if it is not registered then indeed you have a problem with your configuration. In a CME you need to have the following check your show run:

sccp local Loopback0

sccp ccm 192.168.102.1 identifier 1 version 4.0

sccp

!

sccp ccm group 1

associate ccm 1 priority 1

associate profile 1 register mtp001c58551650

associate profile 2 register confdsp1

!

dspfarm profile 1 transcode

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729br8

codec g729r8

maximum sessions 2

associate application SCCP

!

dspfarm profile 2 conference

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

maximum sessions 2

associate application SCCP

telephony-service

sdspfarm units 5

sdspfarm transcode sessions 5

sdspfarm tag 1 mtp001c58551650

sdspfarm tag 2 confdsp1

-----------------------------

Is really important to have the exact same name on both telephony service and in the associate profile command

Yep, verified and my configuration looks correct.

Could you please upload your show run?

Wait a minute, you were right. I had only a partial command in my config. I added sccp ccm 10.107.10.4 identifier 1 version 4.1 and it worked. Thank you!

Great !!! thx for the rating. have a nice day

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: