08-21-2008 08:50 AM - edited 03-17-2019 09:28 PM
Hi,
I configure the XM with IPIP function and it works fine. However, I find that some calls will go to dial-peer 4403. It seems that some calls fail to terminate to dial-peer 4401 and 4402, it flows to dial-peer 4403.
I would like to enable the "condition overflow" function below
- All calls must go to dial-peer 4401 and 4402 for normal situration. The call will not flow to dial-peer 4403 if the gateway 192.168.16.20 OR 192.168.17.120 are up.
- When the gateway 192.168.16.20 AND 192.168.17.120 are down, the calls should flow to dial-peer 4403 only.
How do I change the configuration?
rdgs
R1
dial-peer voice 4401 voip
no prefer
destination-pattern 44.
session target ipv4:192.168.16.120
dial-peer voice 4402 voip
prefer 1
destination-pattern 44.
session target ipv4:192.168.17.120
dial-peer voice 4403 voip
Description: Internet
prefer 2
destination-pattern 44.
session target ipv4:202.x.x.x
08-21-2008 09:44 PM
try the following
dial-peer voice 4401 voip
destination-pattern 44.
session target ipv4:192.168.16.120
dial-peer voice 4402 voip
prefer 1
hunt-stop
destination-pattern 44.
session target ipv4:192.168.17.120
dial-peer voice 4403 voip
Description: Internet
prefer 3
destination-pattern 44.
session target ipv4:202.x.x.x
08-25-2008 07:33 AM
Hi,
I try it but the call cannot overflow to "4403" dial peer. There is one call leg only, router cannot find the right dial-peer (voip) when 192.168.x.x gateway are down.
If I enable the gateway, the call can over flow from 4401 to 4402.
Anything I missing?
rdgs
08-25-2008 05:13 PM
try ur origianl config with this voice-calss and simple chabge as the following:
voice class h323 1
h225 timeout tcp establish 3
dial-peer voice 4401 voip
preference 0
voice-class h323 1
destination-pattern 44.
session target ipv4:192.168.16.120
dial-peer voice 4402 voip
prefer 1
voice-class h323 1
destination-pattern 44.
session target ipv4:192.168.17.120
dial-peer voice 4403 voip
Description: Internet
prefer 2
destination-pattern 44.
session target ipv4:202.x.x.x
and make sure u have the right routing config
i mean u ca ping the internet host and u have two routes! some times it be routing issue!!
good luck
and let me
08-27-2008 08:12 AM
Hi,
Some calls still flow to dial-peer 4403 if 4401 and 4402 fail to terminate the calls.
Any work around or solution for "condition overflow"? Thanks
rdgs
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: