08-21-2008 02:17 PM - edited 03-15-2019 12:46 PM
I've setup some test phones to work on configuring a Call Center and its working great. My next question is how does it know which phones are active? If onlyone individual is answering the phone how does it know not to route to the an unmanned phone?
08-21-2008 02:43 PM
Hi John,
In a standard Call Centre setup the calls will only be routed to an Agent that is Logged In and available to take calls. All calls that cannot be routed to an Agent immediately will be Queued up to listen to MOH or Messaging. Once an Agent becomes available the next caller in line will be routed accordingly :)
Hope this helps!
Rob
08-21-2008 02:52 PM
That's my question is how do I configure the phones so the system knows someone is using it. We are not using the Call Center software on the computer. Thanks!
08-21-2008 06:39 PM
but you are using the contact centre software right? if so, then you can program a the ip phone service for the user to log into the system via the phone.
http://cisco.com/en/US/products/sw/custcosw/ps1846/products_tech_note09186a008029e6d5.shtml
08-22-2008 08:15 AM
I'm not sure what the contact center software is? I'm not sure if we have it!
08-22-2008 05:03 PM
k but you said you had setup some new phones for the contact centre right? what exactly did you do so far?
if possible a little background on its operation would be great
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide