08-22-2008 09:18 AM - edited 03-11-2019 06:34 AM
I'm still running asa723-k8.bin. I've just copied asa804-k8.bin to an ASA5505 trying to upgrade. My problem is that if I now do a 'wr mem', I get the following.
Building configuration...
Cryptochecksum: 42f9323 .....
%Error opening disk0:/~/asa804-k8.bin (Directory doesn't exist)
Error executing command
[FAILED]
sh running-config works, but if I do a 'sh startup-config', nothing is printed.
Any ideas?
08-22-2008 09:24 AM
Appears the asa804-k8.bin is not in the proper directory. Do a "dir flash:", you should see the .bin file there. If not, copy it again to the proper directory. disk0:/asa804-k8.bin
08-22-2008 09:31 AM
I do a 'dir flash:' and I see the asa804-k8.bin file in the listing w/ the other files. I've recopied and get the same results.
08-22-2008 09:36 AM
What about...
boot system disk0:/asa804-k8.bin
08-22-2008 09:41 AM
That command seems to run fine, I execute it, and it just returns to the prompt. However, I still have the previous errors.
And if I run the command a second time, I get:
Error: Unable to set this url, it has already been set
Remove the first instance before adding this onoe.
08-22-2008 09:42 AM
show run boot
If you see "boot system disk0:/~/asa804-k8.bin" then get rid of it.
no boot system disk0:/~/asa804-k8.bin
08-22-2008 09:49 AM
Thank you, that fixed it.
08-22-2008 09:51 AM
No problem. If you use the ASDM you will also need
asdm image disk0:/asdm-613.bin
Please rate any helpful posts.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: