Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
276
Views
0
Helpful
1
Replies

1242 LWAPP AP + Bridge

smitty6504
Level 1
Level 1

‎08-22-2008 11:50 AM - edited ‎07-03-2021 04:22 PM

Is it possible to have a 1242 connect to a 1242 via the A radio for a bridge and then service clients on the B radio? The ethernet connection is setup on LWAPP. How could i go about doing this or is there some documentation someone could point me in the right direction?

Labels:
0 Helpful
1 Reply 1

dennischolmes
Level 7
Level 7

‎08-22-2008 12:36 PM

Yes. It is called Enterprise MESH and requires a special license. You will also need to run a special version of MESH code on your controllers for a period of time. See the link below for more details.

http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps6521/prod_qas0900aecd806bde44_ns767_Networking_Solutions_Q_and_A.html

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card