08-22-2008 08:44 PM - edited 03-06-2019 12:57 AM
I m using Catalyst 2900 series xl IOS Version 12.0(5)WC8.. How to configure port mirroring on this switch.. Pls help..
08-23-2008 06:47 AM
Hi,
Can you try
conf t
int fast 0/X
port monitor Fast 0/y
08-24-2008 07:41 PM
how to check port monitor working or not?
08-25-2008 01:25 AM
Hi,
you have to configure SPAN/RSPAN feature in your switch.you can get the document on cisco site.
or tell me full setup where you want to mirror ur traffic.
Regards,
Raj
08-25-2008 02:06 AM
Hi
You can configure SPAN for the monitoring the traffic on to the switch port
08-25-2008 02:15 AM
Hi
Further to discussion attached is the configuration and monitoring example
Switch-A# configure terminal
Switch-A(config)# monitor session 1 source interface fastEthernet0/2 both
Switch-A(config)# monitor session 1 destination interface fastEthernet0/3
Switch-A(config)# exit
Switch-A# show monitor
Session 1
---------
Type : Local Session
Source Ports :
Both : Fa0/2
Destination Ports : Fa0/3
Encapsulation: Native
Ingress: Disabled
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: