How To Transfer an inbound call on FXO

Unanswered Question
Aug 23rd, 2008

Hi.i have a problem on transfering my inbound calls on fxo to a specific fxs port.i have connected my GW to pbx with one fxo line,so when i dial that spesific line number(on pbx) that is connected to my router after two beep router picks up the line and provides dial tone now i can dial my fxs port DN, but i want that when i call my GW it pick up and then automaticly transfer my call to a spesific fxs port,how is this possible.(i have tried incoming called-number X where X was one of my fxs numbers but it didnt work when i call my GW again it answers the line and provides dial tone for me but not transfering my call to specified fxs port number)

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
bgrunewald Sat, 08/23/2008 - 15:20

Use the command "connection plar" on the FXO voice port. Use the DN of the FXS you want to connect to, and when the FXO answers, it will automatically place a call to the FXS port.

Actions

This Discussion