08-23-2008 01:21 PM - edited 03-15-2019 12:48 PM
I having trouble getting MeetingPlace to outdial, MeetingPlace receives incoming calls but not outgoing.
08-25-2008 07:45 AM
Hello Nelson,
Could you please tell us how MP is integrated with CUCM? are you using a trunk or a gateway?
Anyhow, check the CSS of the integration and make sure that it has the partition that contains the route patterns, you could use the same CSS that you have on your phone.
In addition, if the problem persist after checking the CSS, could you please send us a test trace?
Thanks!
08-25-2008 09:43 AM
Is it integrated via a gateway. Everything is using the
08-25-2008 10:10 AM
Nelson,
Use the same CSS of a working phone and restart the gateway after doing that, below you will find a link that explains how CSS/Partitions works:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/6x/dialplan.html#wp1044276
Hope this helps!
08-25-2008 10:21 AM
Configured Partition and CSS no luck. I am getting H323:Error while getting PSTN code:-1.
As I said before incoming calls are working fine.
Is there something I need to add to the Audio Server to tell it where to send outbound calls?
08-25-2008 11:02 AM
Nelson,
The CSS on the GW will allow calls from the GW (MP) to the CCM. MP Express should hit dial-peer that you have on the Integration GW and then, the RP that you have on CCM.
Please send us a trace file and a debug from the GW for us to check what is going on.
Thanks!
08-25-2008 11:14 AM
08-25-2008 11:34 AM
08-27-2008 03:59 AM
Redid the gateways and rebooted the CallManager everything is good to go.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide