08-23-2008 07:33 PM - edited 03-06-2019 12:58 AM
Hello,
My current Cisco Router 1812 configs. are as:
1. My DSL connects to the FE0 port.
2. My ports FE2-FE9 are automatically assigned IP addresses via the DHCP server from VLAN 1.
What I want to do is stay on the same vlan but assign my printer which is hooked up to my FE2 port a static IP how do I go about doing this.
08-23-2008 07:40 PM
Hi,
I am assuming you are using IOS version 12.4. Here is how you can create DHCP manual binding:
Please see the following link for configuration example:
HTH,
jerry
08-23-2008 08:34 PM
I dont know i set everything up via SDM so it was easy to configure.
08-24-2008 08:00 AM
Hi,
Under SDM -> DHCP, you should see "DHCP Bindings". You can configure MAC address and IP address mapping manually.
Make sure the "Identifier" is Hardware address
and "Type" is IEEE 802.
HTH,
jerry
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide