08-24-2008 04:31 AM
I have a PIX 515E, I need to do static NAT between my exchange server and the public IP which is seating in my inside network, I need a VPN to access the citrix server and I need a PAT with the outside interface of the PIX.
Below is my network layout, I tried to do the configuration but both the configurations are not working.
Kindly help suggest some sample configurations; I will be rating the suggestions.
08-24-2008 06:30 AM
Regarding the STATIC outside >> inside natting have a look at this link:
This document is for mail, the CITRIX configuration is the same, just need to know the ports used.
For dynamic NAT/PAT you just need two lines:
nat (inside) 1
global (outside) 1 interface
Regards
Farrukh
08-24-2008 08:29 PM
Dear Farrukh
Thank you for your suggestions, can u please help us on the VPN also.
Regards
Harish Babu
08-24-2008 09:26 PM
What kind of VPN are you looking for?
VPN Remote Access?
Regards
Farrukh
08-24-2008 10:19 PM
Remote access VPN to access my internal network.
Regards
Harish Babu
08-25-2008 04:24 AM
Please have a look at these two documents, you can start from these and get back to the forum if you need any further assitance:
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080702999.shtml
Please rate if helpful.
Regards
Farrukh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: