Configuring FXO Line

Unanswered Question
Aug 24th, 2008
User Badges:

Hi,

I have a CCME 4.2 installed on a 2821 Router and FXO connected to it. I had connected PSTN line on the FXO.

dial-peer voice 10 pots

destination-pattern 9........

port 0/3/0..

I am unable to make outgoing/ incoming calls. pls help....

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Michael Owuor Sun, 08/24/2008 - 13:02
User Badges:
  • Cisco Employee,

Hi Pradeep,


What number are you dialing for outbound calls? Should that call go out of dial-peer 10?


This link shows a sample configuration of configuring a CME router to allow basic inbound and outbound calls.


Configuring SCCP Phones for Making Basic Calls:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmebasic.html#wp1043996


If after configuring everything you still have the problem, post your updated configuration, as well as the output of debug voip ccapi inout, collected while recreating the problem.


Hope this help.


Regards,

Michael.


Marwan ALshawi Tue, 08/26/2008 - 18:28
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

for incoming calls


lets say u have internal phone with number 222

u want it to recieve the FXO incoming calls


on ur CME

do


port 0/3/0

connection plar-opx 222


for out going make sure u have configured the right dialpeer on on ur CME


keep in mind that based on ur dialpeer 10 after the matching happens the CME will remove the 9 from the dialed number and send the rest based on this dial peer

good luck


if helpful Rate

Actions

This Discussion