08-24-2008 11:40 PM - edited 03-15-2019 12:48 PM
I keep getting "channel-group 0 is already defined "
here is the config
controller T1 0/3/0
framing esf
clock source internal
linecod B8zs
channel-group 0 timeslots 16-23
when I add
pri-group timeslots 1-15,24
I get "channel-group 0 is already defined"
What seems to be the problem??
08-25-2008 02:56 AM
this channel-group 0 timeslots 16-23 in channel group 0
u need to defie the other one which is
pri-group timeslots 1-15,24
in another channel gorup
for example channel group 1 or 2
good luck
if helpful Rate
08-25-2008 04:05 AM
Thanks for your help. However, I am not trying to create another Channel group. I already have that for Data all I need is add Pri-group for voice.
08-25-2008 04:04 AM
The VWIC cards only have a single HDLC controller on them, so they can operate purely as data via a channel group, or dedicate this HDLC controller to the ISDN D channel for common channel signaling operation.
With the VWIC's, you cannot run a channel group AND normal ISDN operation on the same physical interface.
08-25-2008 04:12 AM
how do I dedicate the HDLC controller to the ISDN channel? I have seen couple of examples where VWIC-MFT1 is used for
channel-group and PRI-group on the same interface?
08-26-2008 02:04 AM
I found the solution:
when you assign a channel-group number the number which would be the beginning channel number of your channel group
Example:
I want to split a T1 between pri (voice)1-15 and Data 9(16-23)
so the config has to be:
pri-group timeslots 1-15
channel-group 16 timeslots 16-23
if you use any number from 1-15 you get an error
The channel has already been assigned to cas, pri, or tdm group
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: