Region config

Unanswered Question
Aug 25th, 2008

I have a scenario where in CCM 2 regions are configured. Region A has defined G.711 as the codec to be used when a call is made to region B over WAN. Problem is, Region B has defined G.729 as the codec while calling region A.

What will be the result when 2 regions try to call each other?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
jbarcena Mon, 08/25/2008 - 06:37

Mmmmhh, are you sure? because you should have the same codec on both, in fact if you change it in one it should automatically change it on the other one.


This Discussion