I have a Cisco 871 Ethernect access Router. While configuring the Router, it became inoperative. I would like to know if there is a procedure to reset the Router to its default configuration? If so where could I get the procedure?
Quick question, if you do the rommon again, do you have access to it? If yes, do that and use the following info to gain access back to the router:
Router is trying to download the config from an external source....
This is the procedure when you have access to it:
If you don't have access to it, get into rommon by pressing "Break" on your keyboard during initial boot up and using:
rommon 1>confreg 0x2142
and then use the steps of first link to reset it and changing it back to 0x2102