cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
523
Views
0
Helpful
1
Replies

a problem with an installation RME packages in LMS 2.6

ROMAN TOMASEK
Level 1
Level 1

The customer cann't install RME packages from Cisco.com. The error messages occur. The output from the Activity.log is in the attachment. Thank you.

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

I'm betting this is RME on Windows. Package problems such as this are almost always indicative of a bad RME installation most likely due to long TEMP and TMP environment variables, anti-virus software, and/or installation from a non-Administrator account.

Unfortunately, correcting these problems are not always straight-forward. If you are missing packages that should have been installed as part of an RME update, there is no way to reinstall them without completely reinstalling RME. It would be best for you to open a TAC service request, and have them walk you through the necessary steps.

View solution in original post

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

I'm betting this is RME on Windows. Package problems such as this are almost always indicative of a bad RME installation most likely due to long TEMP and TMP environment variables, anti-virus software, and/or installation from a non-Administrator account.

Unfortunately, correcting these problems are not always straight-forward. If you are missing packages that should have been installed as part of an RME update, there is no way to reinstall them without completely reinstalling RME. It would be best for you to open a TAC service request, and have them walk you through the necessary steps.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: