cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
246
Views
0
Helpful
1
Replies

Pix lock out

ocer714ca
Level 1
Level 1

I have a Pix-535. It was running fine for couple of weeks, until I turned it off and on again. After that, the pix run for 5 to 10 minutes and the begin lock out traffics and console. If I did a reboot on it, it doing the same thing.

1 Reply 1

Hi,

Do you have syslogs leading up to and during the time of the problem?

Also, I would recommend periodically checking the output of 'show cpu' and 'show memory' to see if the values are steadily increasing leading up to the time of the problem.

Hope that helps.

-Mike

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card