HP Procurve 9300 switch (Foundry) to Cisco Connectivity at IP layer on 10GE

astanislaus · ‎08-26-2008

Layer 2 is up, but can't ping even a directly connected interface from HP Procurve 10GE port to Cisco 10GE port.

jsivulka · ‎09-01-2008

I would recommend you to configure 'Active' mode on either HP procurve end or switch end for ether channel to work as desired.

The following URL will help you:

Giuseppe Larosa · ‎09-01-2008

Hello Alphonse,

I've noticed that in your sh int te4/1

Last input 00:14:40, output 00:00:40, output hang never

It looks like it is not receiving any frame.

try

sh ip arp 10.34.252.26 on C6506

do you see an entry ?

also to help ARP

int te4/1

ip proxy-arp

ip redirects

Hope to help

Giuseppe