HDD in RAID replacement

Unanswered Question
Aug 26th, 2008

Hello everyone,

I've got one of the HDD in RAID on 100 model failed. I have tried to replace it with one on my hands (WD2500JB-00REA0). HDD was detected but I could not rebuild a RAID according to procedure. So question is should I use Cisco spare only or this problem could be related to raid controller failure?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mhellman Wed, 08/27/2008 - 05:06

You don't mention what version of MARS, but we've had problems replacing hard disks in the past. TAC seemed to have conflicting information about the steps to replace a "hot swappable" disk.

You should definitely be using a Cisco supplied HDD and I wouldn't expect much support from Cisco otherwise.

Actions

This Discussion