Autonomous To Lightweight Mode Upgrade

Unanswered Question
Aug 27th, 2008
User Badges:

I use the upgrade tool and upgrade couple of my Autonomous AP's. Upgrade completed successfull. When I check the WLC, these AP's are downloading the new image. Looks like after downloading, they reboot and never report back to WLC.

Any idea why?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Rob Huffman Thu, 08/28/2008 - 05:14
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Primesh,

There are some good solutions in these two docs;

Self-Signed Certificate Manual Addition to the Controller for LWAPP-Converted APs

LWAPP Upgrade Tool Troubleshoot Tips

Hope this helps!


Scott Fella Fri, 08/29/2008 - 05:17
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Console into one of the ap's that you upgraded and see what error shows up when the ap tries to join the wlc. This can help pinpoint what is the real issue.


This Discussion