HSRP interface tracking

Unanswered Question
Aug 27th, 2008
User Badges:

I have two cisco routers one of them had two internet connection while the other one had only on internet connection , I need to configure interface tracking for both internet connection so that if the two serial interfaces on the first router goes down the second router becomes the active??how to achieve this??

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sachinraja Wed, 08/27/2008 - 23:06
User Badges:
  • Red, 2250 points or more

hello mohammad,


you can just do a normal standby track command on both the serial interfaces


interface ethernet0

ip address 10.1.1.1 255.255.255.0

standby ip 10.1.1.3

standby priority 110

standby track serial0

standby track serial1


Refer to the following URL for more info:


http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094a91.shtml#intracking


Hope this helps. rate replies if found useful.


Raj

mohammady Wed, 08/27/2008 - 23:22
User Badges:

I knew the above configs for sure, but I dont want the second router to become the active one when one of the serials on the first router goes down ...only when both interfaces are down the second router becomes the active

Ian Wilson Thu, 09/04/2008 - 08:32
User Badges:

If the priority of the Standby router us the default value of 100, then the following config will only drop the active router priority below 100 when both serial interfaces are down:


interface ethernet0

ip address 10.1.1.1 255.255.255.0

standby 1 ip 10.1.1.3

standby 1 priority 120

standby 1 preempt

standby 1 track serial0 15

standby 1 track serial1 15



Rgds,

Ian


Actions

This Discussion