Locations based CAC and voicemail

Unanswered Question
Aug 27th, 2008
User Badges:

Hi


I have a few remote sites that all uses call manager for call control. I have all directory numbers on all phones in all remote sites in a single INTERNAL-PT partition. I would like to configure the system to send all calls out the loca gateway on the each remote site but send voicemail over the WAN.


So, I would not like anyone to be able to call the internal directory number of anyone else except those in there local site. They do not have ta apply AAR as no 5 digit dialling is to be configured. I just want to send all calls over the PSTN except for voicemail.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Thu, 08/28/2008 - 01:20
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

u can achieve it through partions and CSS


in some sijuations u might need to use translation pattrens in conjunction with CSS and partions too


if helpful rate



Ayodeji Okanlawon Thu, 08/28/2008 - 01:42
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

What you need to do is this


1. Create CSS for each site..eg CSS_SITE1, CSS-SITE2, CSS-SITE3


2. Create PArtition for each site eg PT-SITE1, PT_site2, PT_site3.


3. Assign each site PT to its relevant CSS only. SO CSS-SITE1 will only have PT-Site1


4. Assign CSS and PT to each phone in the respective sites.


5. You will need to create 1 Route pattern per site. SO you will have 3 Route patters for a single destination for the 3 sites..


eg..9074XXXXXX in PT_site1

9074XXXXXX in PT_site2

9074XXXXXX in PT_site3


This way, since the phones only have access to the PT for their sites, they will be forced to use the gateways int heir site.


HTH, pls rate useful posts




Actions

This Discussion