PIX 501 configuration with Cable modem

Answered Question
Aug 28th, 2008

How do you configure the outside interface to receive its IP address from a dhcp server? (in this case, from a cable modem)

I have a 501 PIX running 6.3.5

Also, after you configure the outside interface for dhcp, how do yu configure the route so everyone on the inside can see the internet?

I have this problem too.
0 votes
Correct Answer by Farrukh Haroon about 8 years 3 months ago

Version 6.x:

ip address outside dhcp setroute

Remove any default gateways from your config.

7.x/8.x:

int eth0/x

ip address dhcp setroute

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806c1cd5.shtml#client

Please rate if helpful

Regards

Farrukh

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
insccisco Thu, 08/28/2008 - 08:58

It worked!!....

I don't know why the route statement has to be ommited, but works...

thank you very Farrukh

Actions

This Discussion