management-acces on Router 3825 via VPN (snmp)

Unanswered Question
Aug 29th, 2008
User Badges:

Hi,


I'm using "management-access" command on all PIX I manage to get snmp info from ipsec tunnel (management-access inside) => no problem


Now I'm new with router conf, and I did not find the same command to do that.


So how to access inside interface from VPN... and in my case to get snmp info ?


thanks by advance


Regards


Nicolas

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Burts Fri, 08/29/2008 - 09:07
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Nicolas


One of the differences between routers and PIX is that the router will accept managment traffic such as SNMP on all interfaces without requiring any special configuration. The PIX requires configuration to accept management protocols and the router does not require this.


HTH


Rick

nvanhaute Fri, 08/29/2008 - 09:38
User Badges:

hello Rick,


on PIX, I just put "management-access inside" then snmp config ... that's all, all works like a charm via VPN


so if I understand well what you said, on router I just need to configure snmp and that will work ?


thx


Nicolas

Farrukh Haroon Fri, 08/29/2008 - 12:05
User Badges:
  • Red, 2250 points or more

Yes, as I replied to you on the other thread. A router by default allows ALL traffic to ALL its interfaces unless you are running some firewall type feature.


Regards


Farrukh

Actions

This Discussion