08-29-2008 03:12 AM
Hi,
I'm using "management-access" command on all PIX I manage to get snmp info from ipsec tunnel (management-access inside) => no problem
Now I'm new with router conf, and I did not find the same command to do that.
So how to access inside interface from VPN... and in my case to get snmp info ?
thanks by advance
Regards
Nicolas
08-29-2008 09:07 AM
Nicolas
One of the differences between routers and PIX is that the router will accept managment traffic such as SNMP on all interfaces without requiring any special configuration. The PIX requires configuration to accept management protocols and the router does not require this.
HTH
Rick
08-29-2008 09:38 AM
hello Rick,
on PIX, I just put "management-access inside" then snmp config ... that's all, all works like a charm via VPN
so if I understand well what you said, on router I just need to configure snmp and that will work ?
thx
Nicolas
08-29-2008 12:05 PM
Yes, as I replied to you on the other thread. A router by default allows ALL traffic to ALL its interfaces unless you are running some firewall type feature.
Regards
Farrukh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide