cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
376
Views
0
Helpful
2
Replies

CH E1

msasikumar
Level 1
Level 1

can any one helpout to me?

How to do configure the channalaized E1 on Cisco 7206 and in that multichannel card is there

2 Replies 2

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Asi,

if you are using a channelized E3 multichannel E3

you need to go though two levels hierarchy:

define and configure E3 controller

define and configure each child E1 controller

http://www.cisco.com/en/US/products/hw/modules/ps2033/products_data_sheet09186a0080091d25.html

or if you are using a multichannel E1

http://www.cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/voice/MIX-mc_t1.e1_install_config/3608conf.html

Hope to help

Giuseppe

Hi Sasi,

To sum it up, you must define the controller for channelized E1/T1 (E1 in your case)

"controller E1 1/0

channel-group 30 timeslots 1-31 "

//where 1 is your row#,0 is your module #

"interface Serial3/1:30"

// So only difference in channalized E1 and serial E1 is that you have to define 30 channel's grouping, rest is same as for the serial"

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco